After careful consideration you decided to connect them via static route.įrom GNS3: GNS3 is a software that simulate complex networks while being as close as possible from the way real networks perform, all of this without having dedicated. As the administrator of the network, you are tasked to connect them so that employees in the two LANs can communicate with each other. Suppose that your company has 2 branches located in New York and Chicago. The simple syntax of static route: ip route destination- network- address subnet- mask. OSPF, EIGRP and BGP (RIP is also a dynamic routing protocol but it is not mentioned in ROUTE). With dynamic routes, routers can communicate with each other to exchange routing information. Dynamic routes, on the other hand, use a routing protocol to determine the best path and the routes can be changed depending on specific parameters (like bandwidth, delay, cost. Static route is often used when your network has only a few routers or there is only one route from a source to a destination. Static route tells the device exactly where to send traffic, no matter what. In this tutorial we will connect two routers via static route with GNS3.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |